Overview of silicone rubber heater:
The silicone rubber heater (SCS) is composed of two glass fiber cloths and two-piece laminated silicone rubber. The flexible electric heating membrane element is a collection of high temperature resistance, high thermal conductivity, good insulation performance, good strength silicone rubber, high temperature resistant fiber reinforced materials and metal heating film circuits. Because it is a thin product (standard thickness is 1.5 mm), it has good flexibility and can be in close contact with the heated object. The heating element is made of nickel alloy alloy foil, the heating power can reach 1.2W/CM2, and the heating is more uniform. In this way, heat can be transferred to any place needed
The main purpose of electric heater:
1. Silicone rubber heater can be used in humid, non-explosive gas occasions, industrial equipment pipelines, tanks, etc. for mixing and heat preservation (oil drum heater), and can be directly wrapped on the surface of the heated object.
2. It can be used as auxiliary heating for freezing protection and air-conditioning compressors, motors and other equipment.
3. It can be used as medical equipment (such as blood analyzer, test tube heater, medical and health care body shaper, body shaping and slimming belt to compensate for heat, etc.).
Silicone rubber heating belt with 3M glue.jpg
Technical parameters of silicone rubber heater:
1. Insulation resistance: ≥5 MΩ
2. Compressive strength: 1500v/5s
3. Voltage: 220V/380V
4. Power deviation: ±8%
5. Insulating material temperature resistance: 250 ℃
6. Operating temperature: below 250 ℃
7. Suitable temperature: 150 ℃
Instructions for use of silicone electric heating film:
1. In the case of dry burning in the air, the power density should be less than 1 W/cm2 due to the temperature resistance of the material; in the non-continuous working condition, the power density can reach 1.4 W/cm2.
2. The working voltage selection is based on the principle of high power-high voltage and low power-low voltage, and special needs can be listed.
Note: It can be produced according to the voltage, power, and specifications required by the user. The shape of the product can be customized. Instructions for use; end plate, simple and moisture-proof, can not be used in water or frosted places for a long time.
3. Pay attention to the use of this type of electric heating device, its continuous working temperature should be less than 240℃, and the instantaneous temperature should not exceed 300℃.
4. The silicon rubber electric heating device can be operated and pressed, that is, the auxiliary pressure plate is used to make it close to the heated surface. At this time, the heat conduction is good, and the power density can reach 3W/cm2 when the temperature of the working area does not exceed 240℃.
5. The allowable working temperature is less than 150°C under the adhesive installation conditions.
For detailed technical indicators and special requirements, please contact the manufacturer of the heater.




