The following silicone electric heating film manufacturers will introduce you to the small attention to the use of silicone heating films:
1: Do not make fixed decorations or place legless furniture on the floor of the far-infrared heating plate as much as possible. (If you have legless furniture, consider giving it away) to prevent local heat dissipation. Do not place it on it for a long time when the temperature is high. Quilts, cushions and the like, otherwise the temperature under the quilts and cushions will overlap, gather heat, and generate high temperatures, which will damage the film and the floor.
2: It is strictly forbidden to lay flame-retardant objects on the heating area of the electric heating plate
3: It is strictly forbidden to nail nails on the floor and floor tiles of the paved electric heating system
4: Keep clean when laying (cutting) the floor or floor tiles on the heating plate. Do not leave debris, sharp wood chips, nails and other things on the heating plate to avoid damage to the heating plate.
5: Turn off the floor heating or low temperature setting when you are out or when there is no one in the room.
6: It is recommended to choose branded flooring for laying the floor, the thickness is best to be about 0.8, too thick heat transfer is not good, not energy saving, the floor environmental protection index is relatively high, so there is no need to worry about harmful gases. If you find any peculiar smell, you should cut off the power and stop using it in time , Find out the cause in time and accurately, and deal with it in time to ensure safe use.
7: For normal use, it is recommended to set the temperature below 35 degrees. The first time it is used for warming up or if it has not been used for a long time, it should be started from low temperature. After running at 15-20 degrees for a period of time, adjust to the ideal set temperature.
8: The ground must be covered with an insulating layer, and the thickness of the insulating layer can be increased in the cold northern area (or the ground on the first floor). This will have a better effect.
9: A thermostat should be installed in each room. The thermostat should be installed on an inner wall that is easy to operate, and should not be installed in a location that is blocked or cold wall and direct sunlight.
10: The temperature controller should choose accurate temperature control, the control area should be larger than the area of the electric heating plate, and the contact should be pasted on the back of the film. The black stripe heats up.
11: It is strictly forbidden to place objects that are not conducive to heat dissipation at the contact position of the thermostat, otherwise it will cause inaccurate temperature control, and the temperature of the entire electric heating plate will be unbalanced. The temperature has been sensed to the set temperature (such as 30`C), but the other areas of the film have not actually reached the set temperature of 30`C.
12: The thin paste technique should be used for laying floor tiles. The mortar cement should be around 3-4cm. The moisture content of the mortar should not be too much. The electric heating plate should be put in a plastic bag.
13. Do not use sweat soaking.
14. If the current-carrying strip (copper sheet) of the electric heating plate is damaged (stepped on or broken), it will cause ignition, so be careful when transporting and installing this part.
15. When using the energy cloth in the steam room, it is forbidden to stick it directly on the surface of the heating plate or use it at the bottom of the kick.




