In the previous article, I mainly explained how to use the multimeter correctly. Generally, the multimeter will be abnormal during the use. This article summarizes these problems.



Set the measurement range
Before measuring the data, first adjust the gear of the multimeter to the actual value range. This requires knowing the approximate range of the measured value in advance. For example, if you know that the voltage to be measured is about 12v, the latest value on the multimeter is 10v and 25v, then Choose the 25v gear.
One thing to note is that if you are not sure of its size when measuring current, you should adjust the current range of the multimeter to the first range to avoid damage to the multimeter if the current exceeds the range.
Adjust the scale range
When the multimeter is connected, if the pointer points to 0 scale, please reduce the range, otherwise if the scale points to the maximum, please reduce the range.
Precautions for measuring resistance
Before measuring the resistance value, be sure to disconnect the power of the multimeter and remove the power supply battery in order to obtain the most accurate resistance value. If the power is detected, it will interfere with the resistance data, and sometimes even damage the multimeter.
Precautions for measuring current
To measure current, a path needs to be formed, including the "series connection" of the multimeter and the test element. For example, as shown in the figure above, disconnect a wire from the battery terminal, and then connect the multimeter probe to the wire to form a closed circuit.
Precautions for measuring voltage
When measuring the voltage, please measure it as shown in the figure above, it needs to be connected in parallel with the measured component.
Instrument calibration before measuring resistance
The multimeter meter has an additional dial, which is used to adjust the resistance, usually marked with Ω. Before making resistance measurement, connect the two probe ends. Turn the dial until the ohm scale reads zero, and then perform the actual measurement.
The above are some precautions for using a multimeter. We welcome you to add anything that is not comprehensive.