Instructions for use of electric heating film
1. When using this type of electric heating device, it must be noted that its continuous operating temperature should be less than 240℃, and the instantaneous temperature should not exceed 300℃.
2. The silicon rubber electric heating piece can work and press the state, that is, the auxiliary pressure plate is used to make it close to the heated surface. At this time, the heat conduction is good, and the power density can reach 3W/cm2 when the temperature of the working area does not exceed 240℃.
3. The allowable working temperature is less than 150℃ under the condition of sticking installation.
4. In the case of dry burning in the air, the power density should be less than 1 W/cm2 due to the temperature resistance of the material; the power density can reach 1.4 W/cm2 under non-continuous working conditions.
5. The working voltage selection is based on the principle of high power-high voltage and low power-low voltage, and special needs can be listed.
Silicone electric heating has extremely fast heating speed, uniform temperature, high thermal efficiency, high strength, convenient use, long safety life, and not easy to aging.
Silicone electric heating can also choose the size, hardness and thickness, power, voltage and other related parameters.
This type of electric heater also has other names, such as: silicone heater, silicone rubber heater, silicon heater, silicone heater, waterproof heater, Goway silicon rubber heaters, silicon rubber heating element... etc.
