+8613456528940

How to use SIC heating rods correctly?

Jun 18, 2021

For the first use of some customers, we have summarized some experience methods of correct use of silicon carbide rods for your reference:

1. A new furnace or an electric furnace that has not been used for a long time must be baked before use, and use old rods or other heat sources as much as possible when baking.

2. After the silicon carbide rod passes through the rod holes on both sides of the furnace wall, it should be freely rotated 360° to prevent forced installation and knocking. Before the rod is installed, an iron pipe with the same diameter as the rod end can be used for trial installation.

3. The silicon carbide rod is hard and brittle, so be careful when transporting, unpacking, installing and replacing. Handle with care and put it lightly, and prevent mechanical knocks to avoid breaking the rod.

4. When the new furnace starts to transmit power, the voltage should be gradually increased in order to prevent rod breakage. Generally, the starting voltage should be 1/2 of the rated voltage, and then gradually increase the voltage after everything is normal.  

5. If water is discharged during the heating process when the device or material is fired, the resistance furnace used should be provided with an exhaust hole to remove the water or other harmful exhaust gas in the furnace, so as not to affect the service life of the rod.

6. When the stick is stored, pay attention to moisture-proof. If it is found that the aluminum sprayed on the rod end has deteriorated and deliquescence, the aluminum can be sprayed again after surface treatment. If there is no aluminum spray condition, you can wrap several layers of aluminum foil on the rod spray aluminum section for reuse.

7. It is strictly forbidden to use silicon carbide rods with overload. If the rod is broken for some reason or the rod is found to be unevenly heated, and the part is incandescent or dark red for a period of time, this indicates that the rod body is inconsistent with age and the resistance of the section is too different. The furnace should be shut down for maintenance and replaced.

8. The use of silicon carbide rods must be equipped with voltage regulating transformers or thyristor voltage regulators, voltage, ammeters, and temperature automatic control instruments. During use, the resistance of the rod is gradually increased due to oxidation of the rod. In order to keep the furnace temperature normal, the operating voltage should be increased. When the voltage is increased to the high limit of the transformer used and still cannot meet the requirements, the furnace can be stopped and the rod connection mode can be changed before continuing to use.


Send Inquiry