With the development trend of industrial production, laser cutting of stainless steel tubes has long been popularized to stainless steel plate manufacturing companies of various scales. What are the advantages of laser cutting that are favored by mechanical processing and manufacturing companies?
First, the most important point is meticulous quality. The total width of the wound is generally 0.10～0.20mm; high precision: positioning accuracy is 0.05mm, repeated positioning accuracy is 0.02mm. The slit is very narrow. Second, it can greatly reduce costs. The cost of the laser is likely to be much higher than that of the general automatic cutting machine, but the work efficiency is high, and the large-scale production and processing may reduce the production cost of the product workpiece. And it can carry out special-shaped steel products with various shapes. Make high-quality goods.
Naturally, mechanical and automated laser cutting has its own shortcomings. Recently, I received a laser cutting hole from a customer, and it was calculated that exactly a 6-meter stainless steel tube was cut into 5 sections. However, all normal equipment is fixed and the stainless steel tube is produced and processed, and the 20 cm collet cannot be cut. Then it will show that everyone will not be able to cut a section in the end, resulting in the consumption of stainless steel pipes. After that, everyone thought of a method to weld a 6-meter stainless steel tube to a 20-centimeter stainless steel tube for laser cutting. That not only saves a lot of raw materials, but also fulfills the customer's requirements. In the entire process of specific application of stainless steel pipes, because customers must have different requirements, there are also different regulations for custom processing of stainless steel pipes. All normal stainless steel plates are 6 meters in length, but customers are in the whole process of making products. It is possible that the length of 6 meters is likely to cause too much waste, resulting in an increase in customer costs.
I still remember that a customer in Huzhou City once required a batch of stainless steel pipes, but the customer only needed 5.26 meters in the entire process of specific application. If you order 6 meters, the remaining is probably useless. It is only used as waste, and the cost is also high. A lot has been improved. After communication with customers, it was finally confirmed, and the stainless steel pipe order was immediately started from the factory.
