+8613456528940

Why is it not recommended to install floor heating in the kitchen toilet?

Oct 21, 2022

Why is it not recommended to install floor heating in the kitchen toilet?

The kitchen bathroom is not covered with floor heating because the sealing of the kitchen bathroom is not so good, and the cold air outside is easy to come in. It is not safe to install floor heating in the kitchen, after all, the kitchen is a place with more cluttered appliances.


1. If there is no floor heating in the kitchen in the winter to cook in the kitchen will be really cold, floor heating design is to put the water collector in the kitchen, but there is no separate design of the coil, which leads to the temperature of the kitchen is very low, so it is still recommended that everyone in the kitchen should also lay the floor coil separately, so as to ensure the temperature of the kitchen during winter heating.


2. The reason why the bathroom is not equipped with floor heating: the heat dissipation is not good, because the area in the bathroom is relatively small, if the floor heating is used in the coil, the pipe should be bent many times, plus to avoid the floor drain, toilet, sewer, bathtub and other positions, the area that can be laid is relatively small, which will undoubtedly affect the water flow, thereby affecting the heat dissipation effect; Water leakage problem, the most important thing in the bathroom during the decoration process is waterproof, if the waterproof is not done well, it will cause losses to the home, and the most important thing will also affect the neighbors. A waterproof layer must be added on top of the bean stone protective layer. If polyurethane waterproofing is used, the waterproof layer should not be too thick, otherwise it will hinder heat transfer and affect the heating effect.


3. Advantages of floor heating: hygiene, health care, environmental protection, good thermal stability, low usage fee, does not occupy the use area, reduces floor noise, temperature controllability, long service life; Disadvantages: on-site assembly, large randomness; Strong thermal inertness, temperature control hysteresis; One-time molding, difficult maintenance.


Send Inquiry