The hot melt glue gun heating device is a resistance wire.
How to use hot melt glue gun:
1. Before plugging the hot melt glue gun into the power supply, please check whether the power cord is intact and whether the bracket is ready; Whether the used glue gun has been poured glue, etc
Elephant.
2. Please warm up the glue gun for 3-5 minutes before use, and please stand upright on the table when the glue gun is not in use.
3. Please keep the surface of the hot melt adhesive strip clean to prevent impurities from blocking the nozzle.
4. If the glue gun cannot be punched during use, please check whether the glue gun is hot;
If the applicator does not heat up normally, the reasons may be:
1. The applicator power supply is not plugged in;
2, The glue gun burned out due to short circuit.
When the applicator is normally hot, the cause may be:
3. The nozzle is blocked by impurities, and professionals should be asked to deal with it;
4, The glue gun pours the glue and makes the rubber strip thicker, at this time, just rotate the rubber strip gently for a week and carefully pull out a small part back, peel off the thickened part of the rubber strip, and then continue to use.
5. Avoid using sol guns in humid environments, humidity will affect insulation performance and may cause electric shock.
6. The nozzle and melt glue are very high temperature (about 200 degrees) and other parts should not be touched except the handle.
7. Do not pull out the rubber strip from the glue inlet, hot melt adhesive will cause serious burns or damage to the glue gun.
8. Do not disassemble and install some parts of the electric heating at will, otherwise it will cause failure.
9. Keep out of reach of children and store outside of their reach.
10. It cannot be used for any other purpose except melting.
11. If the rubber strip in the glue gun is reversed, please stop using it immediately and use it only after the professional cleans the hot melt adhesive that flows back.
12. If the glue gun is continuously heated for more than 15 minutes, please cut off the power supply.
