+8613456528940

What are the situations where the electric heating element burns out?

Sep 26, 2021

What are the burning conditions of the electric heating film?


I believe that most of the heater manufacturers and friends who use electric heaters have encountered the phenomenon of electric heaters burning out. The problem is simple and easy to solve, so why do such situations occur frequently?


What is the reason for the failure to occur in one and the other in the third? Is it really the manufacturer that can't find the problem? In fact, it is not, the reason for the burning of the electric heating piece is actually so few, the connector is bad, the wiring is not Even, the heating wire piles up, the internal protector fails, and the object is crushed.Besides the possibility of installation, I can't think of other problems that can cause the heating plate to burn out.


40W parallel constant power heating wire.png


Reasons for the burnout of silica gel electric heating pads


The "production process, process supervision" system is not sound. It is simple to make an electric heating film product, but it is more difficult to make a product, especially if it is stable for a long time, it is even more difficult. It needs a good, effective, and implementable The production and supervision to confirm the habits.


The reason for the burning of the electric heating sheet


"Unmanageable" At present, there are too many small domestic enterprises, even many small enterprises, do not set up quality departments, technical departments, and R&D departments, etc., all started with a team of workers under the leadership of a boss. The entire workshop is like shepherd. Human management and unsupervised, resulting in customer complaints are only based on verbal, without actual implementation in place, and ultimately make customers lose patience.


The reason for the burning of the electric heating sheet


"Scheme design" Many people are thinking, what is the difficulty of being an electric heating element? According to the voltage, it can be heated by matching the resistance. It is correct, but the result is wrong. The product design is not only as simple as heating, but also Understand the customer's ideas and design products according to the customer's ideas. During the design process, if there are inappropriate places, you must promptly guide the customer to correct the idea. Don't wait until there is a problem and tell the customer. The way the responsibility is placed on the customer is always wrong, even if the customer is wrong, the correct method should be based on the customer's idea, use environment, use method, and control method as the policy to design a rational and stable product ,


Send Inquiry