What are the burning conditions of the electric heating film? I believe that most manufacturers and friends who use electric heating films have encountered the phenomenon of electric heating film burnout, and they often burn holes, or the joints are burned out, or burned. The heating wire burns out. In fact, the problem is very simple and easy to solve, so why do such situations occur frequently?
What are the reasons for the failure to occur in one and the other in the third? Is it really that the silicone electric heater manufacturer can't find the problem? In fact, it is not, the reason for the burning of the electric heater is actually so few, the connector is bad, The wiring is uneven, the heating wire is piled up, the internal protector fails, and the object is crushed.After eliminating the possibility of installation, I can't think of other problems that can cause the heating plate to burn out.
Silicone rubber heater with 3M glue.jpg
The reason for the burning of the electric heating sheet
<1>The "production process, process supervision" system is not perfect. It is simple to make an electric heating film product, but it is more difficult to make a product, especially the long-term stability is even more difficult. It needs a good, effective, The production and supervision and confirmation habits in place can be implemented.
<2> "Unmanagement ability" At present, there are too many small domestic enterprises, even many small enterprises, do not set up quality department, technical department, and R&D department, etc., all started with a team of workers under the leadership of a boss, and the entire workshop followed the sheep. The same, unattended and unsupervised, caused customer complaints to be based only on verbal, without actual implementation, and ultimately made customers lose patience.
<3> "Scheme design" Many people are thinking about what is difficult to be an electric heater. According to the voltage, it can be heated by matching the resistance. It is correct, but the result is wrong. The product design is not only about heating. Simple, understand the customer's ideas, design products according to the customer's ideas, in the design process, if there are inappropriate places, you must promptly guide the customer to correct the idea, don't wait until there is a problem to tell the customer, I do it according to your idea Yes, it is always wrong to pass the responsibility to the customer, even if the customer is wrong, the correct method should be based on the customer's idea, use environment, use method, and control method as the policy, and design a rational, Stable product,
