Ceramic heating plate is a kind of high temperature and long life heater. In modern industry, the higher and higher working temperature requirements, ceramic heating plate can be adapted, especially chemical fiber, engineering plastics, plastic machinery, electronics, medicine, food and other Kind of pipeline heating, etc.; ceramic heater is formed by a spiral resistance wire passing through specially designed high temperature resistant ceramic tiles, which is extended and bendable. The beautiful metal shell ceramic fiber constitutes the heat insulation layer.
The surface of the electric heating plate is usually a ceramic flat plate, which is suitable for heating glassware. When heating, a magnetic stir bar can also be used for stirring to accelerate the reaction.
Operation method:
1. When using the electric heating plate, put the object to be heated on the surface of the plate first.




2. Turn the temperature adjustment knob and the stirring rate adjustment knob to zero at the same time.
3. Turn on the power switch.
4. Rotate the temperature adjustment knob to set it at a low temperature first, and then slowly increase the temperature according to the required temperature. That is, from LOW, MODERATE to HIGH. Or from 1, 2.... . Slowly increase.
5. Rotate the stirring rate adjustment knob.
6. After use, cut off the temperature adjustment knob, stirring rate adjustment knob and the power switch.
Precautions for use
1. The surface of the electric heating plate is a ceramic plate, and there is no obvious change in appearance when heating. Therefore, when picking it up, you should first approach the plate surface with your hand to find out whether the plate surface is warm or not. If it is warm, please operate it carefully.
2. When the electric heating plate is in use, if the surface of the ceramic heating plate is splashed with chemicals, it should be cleaned up immediately, otherwise the heated material will be difficult to remove after carbonization, which will also hinder the uniformity of heating.
3. Usually only flat-bottomed containers are heated with electric heating plates.
4. The magnetic stir bar is a cylindrical magnet covered with Teflon (PTFE).
5. After the power is turned off, the surface of the board is still very hot, so you need to be careful to avoid burns.