Hot runner systems are divided into fully hot runners and semi hot runners. The design of the adiabatic runner is complex, but the effect is good and the maintenance cost is very low. The structure of the micro semi-hot runner is simple, stable and easy to use, the failure rate is low, and the maintenance cost is low due to the simple structure, which has a greater guarantee for the stability of production.
Hot runner classification: open (for miniature semi-hot runner), needle valve type (for adiabatic runner). The needle valve hot runner saves materials, the plastic parts have a beautiful surface, and the internal quality is tight and the strength is high. There are two main categories of needle valve hot runners (according to the injection principle) in the world: cylinder type and spring type. The cylinder type controls the cylinder pushes the needle valve to close according to the * controller and timing controller, and the structure is more complex, but the design itself is simple. MAINLY DME (USA), INCOE (USA), MOLD-MASTER (CANADA), HUSKY (CANADA), AKAMA (CHINA) AND SO ON. Among them, Japan Century did not enter the Chinese market. The cylinder type because of its structural characteristics determines that the mold accuracy is high, and the debugging and maintenance are more complicated, of which MOLD-MASTER can be called the Rolls-Royce in the hot runner---- heating part is on the nozzle. A large part of them costs in commissioning and maintenance, and customers basically cannot maintain it themselves. Spring type on one - FISA (Japan), the biggest feature, relying on the balance of spring and injection pressure control needle valve switch, assembly debugging and maintenance is simple, mold accuracy is not high, Japanese customers basically have their own maintenance capabilities, widely used in home appliances, automotive trim, precision multi-cavity molds. The difference between the spring type and the cylinder is that it cannot be controlled in timing, and the problem of welding lines cannot be solved well. On the basis of successfully summarizing the experience of thousands of sets of hot runner systems, plastic beauty technicians have successfully developed: small diameter wear-resistant nozzles; Pogo needle valve and internal heating nozzle. Plastic hot runner has developed a mosaic heater, the heater is directly embedded in the copper sleeve, because the thermal conductivity of copper is very good, the copper heater sleeve to the hot nozzle greatly reduces the maintenance cost of the hot runner hot nozzle
The price is positioned or close to (Chinese market price), MOLD-MASTER, INCOE, DME, AKOMA, HUSKY, FISA, SM. In fact, the hot runner mold reduces many requirements for design, and provides great convenience for designers to develop more mold structures. Plastic Beauty not only inherits the leading technology of Canadian hot runners, but also integrates related injection molding on this basis; Electrothermal and precision machining technology. The company makes full use of human resources, and introduces the most advanced on-site production and customer service system to create a management system that fully satisfies customers.



