+8613456528940
Carbon Fiber Heating Wire

Carbon Fiber Heating Wire

High Quality Carbon Fiber Heating Wire is widely used in different areas. Product Model: 24K or 12K carbon fiber heating cable Working voltage: 220V Insulation strength: >500 megohms Temperature resistance temperature: 280 degrees Related Knowledge: What is K represents the meaning of...
Send Inquiry
Product Details ofCarbon Fiber Heating Wire

High Quality Carbon Fiber Heating Wire is widely used in different areas.


Product Model: 24K or 12K carbon fiber heating cable

Working voltage: 220V                               

Insulation strength: >500 megohms                        

Temperature resistance temperature: 280 degrees

Related Knowledge:


What is K represents the meaning of thousands?

1K is a thousand silk, 24K is 24 thousand silk (24000) composition

Different K numbers represent different resistorsl

 

What is the difference between silicone and PTFE?

PTFE/PFA/FEP carbon fiber heating wire

Advantages: Wear, corrosion resistance, no smell

Disadvantages: Relative to the silicone are not soft

Silicone carbon fiber heating wire

Advantages: Resistant to bending, soft

Disadvantages: There is smell


What is the resistance per meter?

1K=400Ohm/m, 2K=220Om/m, 3K=133hm/m, 6K=74Ohm/m, 9K=43Ohm/m, 12K=33Ohm/m, 15K=24Om/m, 18K=21Ohm/m, 24K=17Ohm/m, 36K=12Ohm/m, 48K=9Ohm/m

 

How to calculated power?

Product power calculation:

(Voltage*Voltage)÷(resistance*length)=power

The longer the length, the smaller the power of the heating line

Precautions

The heating wire can not overlap when used! Can not cross!

Cross-over will make the heating line local temperature higher than the melting point of the protective layer, will damage the heating wire!

 

About installation

The normal laying power is 100-160 watts per square. Different areas can be increased or decreased according to the room's own insulation and the type of floor. The installation is very simple, we will guide the installation, the normal laying distance is 12cm.

 

Precautions
The carbon fiber heating wires must not cross between each other during installation and should not be touched with each other. After installation, wait until the concrete floor is fully dried and then heat to prevent the floor from being cracked and twisted due to excessive temperature rise. When using the floor heating for a long time, set the minimum temperature first, then slowly heat up for the same reason.





Hot Tags: carbon fiber heating wire, China, suppliers, manufacturers, factory, custom, wholesale, tire warmer heating element, carbon wire heater, pipe heating cable with thermostat, 24k heating cable, seedling heater wires, internal pipe heating cable

Send Inquiry

(0/10)

clearall