With several factories, we will provide a wide assortment of Brass Nozzle Heater, Stainless Steel Coil Heating Element, infrared quartz heating tubes. The development of our company has been supported by the attention and support of our sales customers and the establishment of long-term cooperation and assistance in information technology. We are a company in the market integrating scale, growth and profitability at the same time.

Description

On tape and rope heaters, heating resistances inside the fiberglass tubes. When it connect to electricity, and the heating resistances heat up and the heat conducted through glass fibers.

Long service life, the insulation material is multi-layer alkali-free glass fiber, with good temperature resistance and reliable insulation performance. The utility model has the advantages of soft structure, can be directly wound on the surface of the heated part when used, and has uniform temperature, simple installation, convenient use, safety and reliability.

Common Specifications

How to install the tape and rope heaters:

Step 1: Pipe Surface Preparation

Prepare surface to be heated: Wipe the surface making sure there is no foreign material, like liquid, on the surface. Foreign material inhibits heat transfer and liquid can damage select models of heating tape (i.e. HighTemperature Heating Tapes).

Make a visual inspection of heating tape: We recommend that you replace the heating tape if it becomes torn or damaged. Damaged heating tape is a safety hazard and will not operate correctly.

Step 2: Heating Tape Installation (wrap)

Heating tape can be installed on nearly any surface due to its flexibility. Spiral wrap the heating tape onto the surface to be heated so that the length of one entire side of the heating tape is in full contact with the surface .The distance between spiral wraps is dependent on the uniformity requirements and the amount of available heating tape. A minimum distance of 1/8" is required between spiral wraps to avoid damage to the heating tape.

Attach the heating tape to the surface by either using built-in tie straps, high-temperature adhesive tape or mechanical clamping devices that will not cause damage to the heating tape.

Ensure the heating tape is not kinked, twisted, or hanging free from the surface.

Do not overlap heating tape on itself.This can cause damage to the heating tape due to overheating.

Step 3: Connecting Your Heating Tape to a Temperature Controlling Device

Your heating tape must be connected to an external temperature control device. Ensure your temperature controller is protected by a properly sized circuit breaker or fuse. Use of a ground fault circuit interrupter is highly recommended and may be required for your installation.

For proper temperature control, secure a thermocouple, RTD, or other sensing device with one strip of adhesive tape so that it is in close proximity to the heater to prevent overheating.

Some Photos for other Production

Write to us for any questions, you are welcome all the time.

We persistently pursue scientific and technological innovation to upgrade our High Insulation of Electric PTFE Film Tape in order to gain a place in the fierce market competition. The company wholeheartedly welcomes new and old customers to visit us and establish long-term and stable business relationships. Our company is based on the business tenet of honesty and trustworthiness, sound operation and standardized operation, highlighting the brand and technology progress strategy.

Hot Tags: tape and rope heaters, China, suppliers, manufacturers, factory, custom, wholesale, snap heating pad, seedling heating cables, semiconductor heating element, compressor heating elements, heating element for heat press machines, low heat heating pad

[[ProKeywords]]